How To Make A Child Chair Out Of Wood: Sellable DIY Project

How To Make A Child Chair Out Of Wood – Build And Sell On Etsy Building a kids bench is an easy woodworking project that adds charm and function to any playroom, garden, or entryway. With just a few tools and materials, here you will find a blueprint on how to make a child chair…

Aleksandrs

September 6, 2025

2–3 minutes

How To Make A Child Chair Out Of Wood – Build And Sell On Etsy

Building a kids bench is an easy woodworking project that adds charm and function to any playroom, garden, or entryway. With just a few tools and materials, here you will find a blueprint on how to make a child chair out of wood.

Table of Contents

Materials & Parts List

Lumber (Pine or similar softwood recommended):

Seat: 1 board, 30″ (76 cm) × 10″ (25 cm) × 1″ (2.5 cm)
Legs: 2 boards, 10″ (25 cm) × 10″ (25 cm) × 1″ (2.5 cm)
Side Supports: 2 boards, 26″ (66 cm) × 4″ (10 cm) × 1″ (2.5 cm)
Backrest (optional): 1 board, 30″ (76 cm) × 8″ (20 cm) × 1″ (2.5 cm)

Other Materials:

Wood screws (2″ / 50 mm)
Wood glue
Sandpaper (120–220 grit)
Non-toxic wood finish or paint (child-safe)

Tools Needed:

Measuring tape
Saw (hand saw or circular saw)
Drill & screwdriver bit
Clamps
Sander or sanding block

Step-by-Step Instructions on how to make a child chair out of wood

Step 1: Prepare the Wood

Cut all boards to size according to the measurements above. Sand each piece to remove sharp edges and splinters.

Step 2: Attach the Legs

Position each leg flush with the short ends of the seat board. Apply wood glue, then secure with 2–3 screws per leg.

Your subscription could not be saved. Please try again.

Success!

Step 3: Add Side Supports

Attach one support board along the bottom inside edge of each leg. These supports provide stability. Secure with screws and glue.

Step 4: Optional Backrest

If you want a backrest, attach the backrest board to the rear of the bench seat with screws angled through the supports.

Step 5: Sand & Finish

Sand the entire bench until smooth. Apply a child-safe finish, stain, or paint. Allow it to dry fully before use.

Finished Dimensions

Length: 30″ (76 cm)
Width: 10″ (25 cm)
Height (seat): 11″ (28 cm)
Height (with backrest): ~18″ (46 cm)

Detailed instructions how to make a child chair out of wood

This small kids bench is a fun weekend project that’s durable, functional, and easy to customize with colors or engravings. Perfect for playrooms, gardens, or as a sweet handmade project to put on sale on Etsy.

Best Wishes,

Alexander

Your subscription could not be saved. Please try again.

Success! Check your email…